For Parts, Service or Technical Advice Call us on (08) 61547938
Common Dishwasher Faults
29/1/2019
Not draining: A very common problem for all dishwashers. If water is not draining from the machine or you are getting a drain error code then it's likely the drain pump has failed or become blocked. We can diagnose this fault, remove the pump and clear any blockages or replace the pump if necessary. Dirty marks on dishes: Your dishwasher is not giving you the results it used too? We can test the unit to ensure all of the components are working correctly to ensure correct operation. It may be that the unit has become clogged from daily use, the heating system has broken down, detergent system not operating or the unit not rinsing correctly. We have the expertise to diagnose the problem whether it’s the heater element, air pressure switch or failed wash pump. Machine constantly running Machine constantly running? This may be caused by a failed water inlet solenoid, timer or control board. We can check and diagnose the fault and replace the failed components as necessary. Water leaks: A very common problem with commercial washers. The faults most usually found are a failed inlet valve, split drain or rinse hose or a corroded rinse tank/boiler. Our technicians carry parts to replace inlet valves and hoses. We can replece your corroded boiler with a new tank made from heavy duty stainless steel to unsure longevity and reliability.
0 Comments
|
Archives
January 2019
Categories |
Contact Us (08) 61547938 service@wacagroup.com Mon- Fri 8.00 - 4.30 wa.appliances@hotmail.com ADDRESS: UNIT 11 / 95 KELVIN RD MADDINGTON WA 6109 |
Give us a call Now
(08) 61547938 |
Note: All images on this website are the sole property of WA Commercial Appliances Australia and must not be used, copied, shared or published without express permission of WA Commercial Appliances Australia.
Proudly powered by Weebly